plastic-formwork-board

Advantages and installation instructions of BZ hollow plastic formwork

Polypropylene hollow construction plastic formwork is an energy-saving and environmentally friendly product that uses polypropylene plastic combined with polymer nanotechnology. It is a new product after wooden formwork, composite steel formwork, bamboo-wood bonded formwork, and all-steel large formwork. It is energy-saving and environmentally friendly, and can completely replace traditional steel formwork, wooden formwork, and square timber, and its amortization cost is very low.

Hollow plastic construction formwork has the advantages of environmental protection, energy saving, economy and practicality. Due to its waterproof and corrosion resistance, it has become the new favorite in the construction industry. This product will gradually replace the wooden formwork in constructions, save a lot of wood resources for mankind, and play a great role in protecting the environment, optimizing the environment, and reducing carbon emissions. Hollow plastic construction formwork is 100% fully recyclable, truly achieving zero waste emissions, and is a revolutionary construction material in the 21st century. The application of several patented technologies more fully improves its effectiveness:

1. Nanotechnology support

Polymer nanotechnology is used to modify the plastic formwork columns. The original “nanopolymer additives” and additives not only ensure the toughness of the formwork, but also increase the hardness of the formwork, increase the flexural modulus of the formwork, and improve the performance of traditional plastic construction formwork. The deformation rate of the defective formwork is controlled within 2mm, and the diagonal line is controlled within 0.5mm, which better meets the construction requirements.

2.Patented production process

The hollow plastic construction formwork adopts the patented “double-machine co-extrusion” process, which greatly avoids deformation caused by thermal expansion and cold contraction, and has unparalleled advantages. The product has high surface hardness, wear resistance, easy demoulding, wide construction temperature range, heat resistance, cold resistance, aging resistance, no warping, and no cracking. It can withstand various construction loads. The product has certain flexibility and can be used in curved constructions, tunnels, bridges, etc.

3. Beautiful appearance and easy splicing

Patented technology is used to transform environmentally friendly pp plastic construction formwork, and the two sides of the formwork are successfully made into a flat surface. The product appearance is more beautiful, splicing is more convenient, slurry leakage is avoided, use is more convenient and safe, and construction is more time-saving and labor-saving.

4. Industry-university-research cooperation

Our company has a strong alliance with the School of Polymer Materials of Chang’an University. And successfully developed nano-polymer materials, which were used in the construction of plastic formwork in my country, improving the quality of the formwork.

5.Installation instructions

1. Use hollow construction formwork laid crosswise with 15mm thickness.

2. (1) The spacing between wooden surfaces and intersections. The spacing between timbers depends on the thickness of the board. The thickness of the concrete is generally less than 0.15m. The spacing between layers is 200~250m. (2) Shear wall or formwork sampling (15mm thick spacing is 100~150mm. If the shear wall column width is greater than 1m, a fixed frame must be added.

3. When die-cutting the shear wall and column puzzle, leave no gaps in the inner corners. The bottom part of the wall must be connected with wooden square beam wall formwork. After making 4 molds for the shear wall, it must be assembled into a whole and hoisted flat, which reduces the labor intensity of the molding effect. good.

4. When the distance between the nails and the edge of the construction is 15~30mm, the strength should be moderate. The length of the nails should be 40~50mm and should not be too long or too short.

5. A 15mm gap must be left for a piece of wood at the bottom of the beam. The gap made on the wall panel will not leak grout and save material for the wall panel.

BZ hollow construction plastic formwork factory looking forward to your inquiry!

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *